Q: will this tweeter fit the large advent?,,, with the fried egg tweeters,,,and if so what mods would i have to do?
A: Yes, but you must re-drill the mounting holes in the cabinet for the 4 wood screws. On some versions you may also need to enlarge the hole cut-out for the magnet.
Q: Will this 85c000017 tweeter direct fit into the existing heritage bezel plate?
A: This unit is larger. Your original tweeter is 3-7/8" x 4-1/2". This unit is 4-1/2" x 6-1/2". Functionally, this tweeter works perfectly in your system however, so if you don't mind modifying the cabinet to fit the new unit, this is a great choice.
Q: Is this speaker interchangeable with Advent original tweeter metrics?
A: Yes, this unit will have the same specs as the P85C00019 which was designed for the original Advent. Primary difference is the face plate size.
Q: I have the above tweeter. 1 connection on the tweeter is red is that the positive. the 2 wires coming out of the cabinet are yellow and 1 black. should the yellow be connected to your red marked connection?
A: Yes, red is positive. Connect the yellow wire to the positive connection on the new tweeter.
Q: Can you provide the specs on this Tweeter? I want to upgrade the Xovers.
A: Impedance: 6 ohms, Re: 4.2 ohms
Power: 80 watts RMS, 120 watts max
Response: 2 kHz - 20 kHz
Sensitivity: 89 dB
Q: Is this for the Advent Legacy 3 by Jensen?
A: Sorry, no. If you want to install this tweeter in the Legacy 3 then you will need to modify the cabinet to fit the new units.
Q: I have an Advent model 5002 speaker. Will this be a replacement for it? Will the only modification to the cabinet be drilling 2 holes as this has a rectangular base?
A: This model can be used as a substitute for the original. You will need to re-drill the mounting holes in the cabinet.
Q: hello, i'm looking for two advent tweeter P85C00017 to replace my broken ones.
I see it's not available, it's out of production.
Are there any alternatives?
A: Yes. We use the ADV-P85C00019. The faceplate is 4.5" x 5.5" on the replacement model.