Q: When you state the size is 3 and 1/2 diagonally is that hole center to hole center or edge to edge?
A: The measurements are edge to edge.
Q: Hi there,
I am searching for replacements for the two tweeters of my Technics SB-CR33.
The original tweeters were TECHNICS EAS65PH313A6 of 8Ohms impedance.
Do you guys think the T-120 would work well replacing those?
A: Yes, we have used the T-120 tweeter as a replacement for your model. They work great!
Q: i have a pair of kenwood 3 way speakers in each cabinet. one 12 inch woofer,4 inch midrange and 2 inch tweeter,8ohms,140 watt maximun imput. will the cone tweeter t-120 work?
A: Yes, the T-120 works great to replace the Kenwood tweeters.
Q: what is the center to center hole dimension (diagonally)?
A: Center to center hole measurement is 2-7/8" (73mm) diagonally across.
Q: will these fit pioneer cs-88a?
A: No, these tweeters are not correct for Pioneer CS-88a's. For the Pioneer CS-88a tweeter we suggest either sending it to us for repair or purchasing our New-Edge-It repair kit PIO-FSK-3P.
Q: Would I be able to replace the tweeters of my Technics SB-2685 speakers with these?
A: Yes, the T-120 tweeter is compatible with many older Technics systems. Please double check the size and hole cut-out diameter of the original to verify the fit before ordering.
Q: I want to replace the tweeters on my speakers but not sure if the T-120’s will work because it says 20w. Ohms are the same though. Help please?
A: The tweeter only "sees" about 10% of the total power to the cabinet because of the crossover. That is why you see 10 watt and 20 watt tweeters used in 100 watt systems.
Q: I have an old Proton 300 desk radio that has a damaged tweeter. I found this speaker and think it will fit the hole that is 2.5". The plate on the old speaker was round and this is square but it sits behind a grill so it shouldn't be an issue. The old speaker was an 8 ohms 10 Watt tweeter. Do you think this would be an issue as the T-120 is 8 ohms and 20 Watts. Will it affect the sound or balance at all? Thanks, Don.
A: The power handling will not be an issue for the sound balance. it simply means that the new tweeter could handle more power if it was ever required to do so. However, it is always a good idea to replace them in pairs if budget allows.
Q: Will this work for a pioneer cs a500 speaker?
A: Yes, but it is slightly smaller than the original Pioneer tweeter. We also sell foam replacement kit part # FSK-3P if you wish to keep the original tweeters and refoam them.
Q: What is the mounting dimension size diagonally?
A: Diagonally these measure 3.5" corner to corner.