Altec 6" x 9" Foam Speaker Repair Kit FSK-6 x 9 (PAIR)

Speakers are as new again. Took us many hours to do it properly though. I wouldn't do it for any speaker, but if a speaker is special to you, go ahead and do it ! We put the foam on top of the cone instead of under it, as stated in the manual it's easier and no difference in performance. Watch out the glue dries very fast on the cone so you have only one shot to position the foam right. When setting the foam to the outer edge though, the glue is a bit slow (different material).

I BROUGHT MY 6X9 ALTEC LANSING SPEAKERS BACK TO LIFE. THESE FOAMS INSTALLED AND FIT PERFECT. HIGHLY RECOMMENDED. THE SUPPLIED ADHESIVE GIVES YOU ENOUGH TIME TO MAKE ADJUSTMENTS.

very good services thanks regards yves

Have had these great speakers and was going to through them out. Then I found your site and tried it , they are as good as new now. Thanks Chris Holtgrewe Laz-It

Very good quality of make, good also for other speakers (JBL), I am satisfied with this option of replacable foam for old but very good speakers. New speakers maybe ar enot so good as this old one.

After doing a bit of research on options I ordered the foam repair kit on line. It arrived very quickly which I appreciated. I read the instructions and went to work, though I altered the advised approach and glued the foam to the back of the cone instead of front as this was the original method. It is a bit tricky as the glue set time takes an initial 10 to fifteen minutes. As long as you monitor it during this time to make sure it does not pull away before the glue sets, you are just fine. Stay task focused and you will do fine. It is joy to again have my favorite speakers in top form as they were when new over twenty years ago. Good product and highly recommended.

Great prod easy fit and excellent customer service

Everything looks of very good quality but I did not have the time to install them yet... But am very confident it will be very good.

Great product. Fit well and adhesive worked well.